Точка доступа Aruba (HPE) JY713A

RAP-203R SERIES SPECIFICATIONS

· Unified flexible radio 802.11ac remote AP with internal antennas.

· Supports wall-box and desk mount deployments

WI-FI RADIO SPECIFICATIONS

· AP type: Indoor, flex radio:

· 5GHz 802.11ac 2x2 MIMO OR 2.4GHz 802.11n 2x2 MIMO¹, or

· 5GHz 802.11ac 1x1 AND 2.4GHz 802.11n 1x1¹

· Software-configurable radio supports 5GHz (Radio 0) and/or 2.4GHz (Radio 1)

· 5GHz: Two spatial stream Single User (SU) MIMO for up to 867Mbps wireless data rate to individual 2x2 VHT80 client devices

· 2.4GHz: Two spatial stream Single User (SU) MIMO for up to 400Mbps wireless data rate to individual 2x2 VHT40 client devices (300Mbps for HT40 802.11n client devices)

· Support for up to 256 associated client devices per radio, and up to 16 BSSIDs per radio

· Supported frequency bands (country-specific restrictions apply):

· 2.400 to 2.4835GHz

· 5.150 to 5.250GHz

· 5.250 to 5.350GHz

· 5.470 to 5.725GHz

· 5.725 to 5.850GHz

· Available channels: Dependent on configured regulatory domain

· Dynamic frequency selection (DFS) optimizes the use of available RF spectrum

· Supported radio technologies:

· 802.11b: Direct-sequence spread-spectrum (DSSS)

· 802.11a/g/n/ac: Orthogonal frequency-division multiplexing (OFDM)

· Supported modulation types:

· 802.11b: BPSK, QPSK, CCK

· 802.11a/g/n/ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM

· Transmit power: Configurable in increments of 0.5 dBm

· Maximum (conducted) transmit power (limited by local regulatory requirements):

· 2.4GHz band: +18 dBm per chain, +21 dBm aggregate (2x2 mode)

· 5GHz band: +18 dBm per chain, +21 dBm aggregate (2x2 mode)

· Note: conducted transmit power levels exclude antenna gain. For total (EIRP) transmit power, add antenna gain

· Advanced Cellular Coexistence (ACC) minimizes interference from cellular networks

· Maximum ratio combining (MRC) for improved receiver performance

· Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance

· Short guard interval for 20MHz, 40MHz and 80MHz channels

· Space-time block coding (STBC) for increased range and improved reception

· Low-density parity check (LDPC) for high-efficiency error correction and increased throughput

· Transmit beam-forming (TxBF) for increased signal reliability and range

· Supported data rates (Mbps):

· 802.11b: 1, 2, 5.5, 11

· 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54

· 802.11n: 6.5 to 300 (MCS0 to MCS15)

· 802.11ac: 6.5 to 867 (MCS0 to MCS9, NSS = 1 to 2 for VHT20/40/80)

· 802.11n high-throughput (HT) support: HT 20/40

· 802.11ac very high throughput (VHT) support: VHT 20/40/80

· 802.11n/ac packet aggregation: A-MPDU, A-MSDU

WI-FI ANTENNAS

· Two integrated dual-band omni-directional antennas for 2x2 MIMO with maximum individual antenna gain of 0.7dBi in 2.4GHz and 1.0dBi in 5GHz. Built-in antennas are optimized for vertical orientation of the AP.

· Combining the patterns of each of the antennas of the MIMO radios, the peak gain of the effective per-antenna pattern is -0.4dBi in 2.4GHz and 0.5dBi in 5GHz.

OTHER INTERFACES

· Uplink: 10/100/1000BASE-T Ethernet (RJ-45, back)

· Auto-sensing link speed and MDI/MDX

· 802.3az Energy Efficient Ethernet (EEE)

· Local: Two 10/100/1000BASE-T Ethernet (RJ-45, back)

· Auto-sensing link speed and MDI/MDX

· 802.3az Energy Efficient Ethernet (EEE)

· One port (E2): PoE-PSE (output): 48 Vdc (nominal) 802.3af PoE (AP-203RP models)

· Bluetooth Low Energy (BLE) radio

· Up to 4dBm transmit power (class 2) and -93dBm receive sensitivity

· Integrated antenna with moderately directional pattern and peak gain of 1dBi

· USB 2.0 host interface (Type A connector, top)

· 3G/4G cellular modems

· Device battery charging port

· Capable of supplying up to 1A/5 watts of power to an attached device

· AC power interface, 2 prong IEC 60320-1 C8 receptacle (back)

· Visual indicators (LEDs, front):

· Power/system status

· Radio status

· Local network port status (2x)

· Includes PoE-PSE status (AP-203RP models)

· Reset/LED control button (“paperclip access”, bottom)

· Factory reset (when activated during device power up)

· LED control: toggle off/normal

· Serial console interface (custom, uUSB physical jack, bottom)

ENCRYPTED THROUGHPUT

· Maximum IPsec encrypted wired throughput: 20Mbps

POWER SOURCES AND CONSUMPTION

· The AP supports direct AC power: 90V – 265V, 47Hz – 63Hz.

· Note that the unit does not include an AC power cord (IEC C7 plug). A compatible region-specific cord should be selected and added when ordering the AP.

· Maximum (worst-case) power consumption: 7.5W.

· Excludes power consumed by external USB and/or PoE-PD device (and internal losses); this could add up to 6W for a 5W/1A USB device and up to 18W for a max load (15.4W) 802.3af PoE-PD device

· Maximum (worst-case) power consumption in idle mode: 4.6W.

MOUNTING

· The AP supports desk mount without additional accessories. A cover ships with the AP to hide connectors, cables and product labels.

· The cover can be used to support wall mounted deployments as well.

MECHANICAL

· Dimensions/weight (unit, with cable cover):

· 155mm (W) x 50mm (D) x 95mm (H)

· 320g (AP-203R), 340g (AP-203RP)

· Dimensions/weight (shipping):

· 224mm (W) x 159mm (D) x 78mm (H)

· 510g (AP-203R), 590g (AP-203RP)

ENVIRONMENTAL

· Operating:

· Temperature: 0° C to +40° C (+32° F to +104° F)

· Humidity: 5% to 93% non-condensing

· Storage and transportation:

· Temperature: -40° C to +70° C (-40° F to +158° F)

REGULATORY

· FCC/Industry of Canada

· CE Marked

· R&TTE Directive 1995/5/EC

· Low Voltage Directive 72/23/EEC

· EN 300 328

· EN 301 489

· EN 301 893

· UL/IEC/EN 60950

· EN 60601-1-1 and EN 60601-1-2

For more country-specific regulatory information and approvals, please see your Aruba representative.

RELIABILITY

· MTBF at +25C° operating temperature:

· AP-203R: 324,000 hours (37 years)

· AP-203RP: 308,000 hours (35 years)

REGULATORY MODEL NUMBER

· AP-203R-xx (all variants): APINR203

· AP-203RP-xx (all variants): APINP203

CERTIFICATIONS

· CB Scheme Safety, cTUVus

· Wi-Fi Alliance (WFA) certified 802.11a/b/g/n/ac

MINIMUM SOFTWARE VERSION

· ArubaOS™ 6.5.2.0/8.2.0.0

· Aruba InstantOS™ 6.5.2.0/8.2.0.0